Assembly instructions in 3D
Pick a cabinet and follow it step by step: turn it with your finger, panels fly into place, and confirmat screws, hinges and supports are shown up close. Steps can be read aloud, and you can move on by voice.
- 1
Pick a cabinet
Each model covers every width - a 400 and an 800 carcass go together in the same order.
- 2
Check panels and tools
Tick off panels, hardware and tools before step one, so you don't stop halfway.
- 3
Follow the 3D steps
Next, back, repeat - with buttons, arrow keys or your voice.
The instructions are made by the same program that makes the cutting list - panels carry the same labels (P1, P2…) and the same number of screws and hinges as the hardware list.
Base cabinets
Drawer units
Drawer unit - chipboard boxes, side runners
Three drawers with chipboard boxes on GTV side runners.
12 steps · 600 × 720 mm
Open instructionsDrawer unit - Blum TANDEM
Chipboard boxes on concealed runners under the drawer bottom.
12 steps · 600 × 720 mm
Open instructionsDrawer unit - Blum TANDEMBOX antaro
Metal drawer sides; only the drawer bottom is cut from board.
12 steps · 600 × 720 mm
Open instructions
Sink and appliances
Sink unit
Rails on edge to leave room for the bowl and trap, two doors.
12 steps · 800 × 720 mm
Open instructionsSink unit with waste bin
Sink carcass; the front pulls out together with the bin.
12 steps · 600 × 720 mm
Open instructionsBuilt-in oven cabinet
Oven niche, fixed shelf and a drawer below.
14 steps · 600 × 720 mm
Open instructions
