Tall pantry cabinet
2070 mm tall cabinet with five shelves and two doors.
Example 600 × 2070 × 560 mm - the same order applies to every width.
Tall pantry cabinet: assembly instructions
- 1
Before you start
Lay cardboard or a blanket on the floor so the panels don't get scratched. Check against the list that you have every panel - labels match the stickers and the cutting list - and all the hardware. The edge-banded edge is the front: always face it forward.
- 2
Left side and bottom
Stand the left side on its edge, drilled face inwards. The bottom sits BETWEEN the sides, flush with the lower and front edge of the side (P1 and P2). Drive 3 confirmat screws through the holes in the side - middle one first, then the ends. Don't fully tighten until the carcass is assembled.
- 3
Top panel
The top panel P3 goes between the sides, flush with the top edge - like the bottom, only at the top. They join the left side with 3 confirmat screws.
- 4
Right side closes the carcass
Lower the right side P1 onto the free ends of the panels already fixed in the left side. Drive 6 confirmat screws through the right side, and only now tighten every confirmat fully.
- 5
Diagonals and back panel
Lay the carcass face down and measure both diagonals - they must match within 1 mm. Only then place the back panel P4 smooth face in, 2 mm in from the edges, and pin or staple it every 8-10 cm into the sides, bottom and rails (about 52). Once the back is on, the carcass can't rack.
- 6
Legs
Lay the carcass on its back and fix 4 legs to the bottom, 4-5 cm from the edges. Set them to plinth height (100 mm) - final levelling is done with a spirit level once the cabinet is in place.
- 7
Supports and shelves
Press the supports into the holes in the sides - 20 pcs, 4 per shelf, at the same height left and right. The shelves P5 rest on them, banded edge forward. Height can be changed later by moving the supports.
- 8
Hinges and doors
Press the hinges (5 pcs) into the Ø35 cups in the doors and fix each with two screws. Screw the plates to the side at the same height as the hinges. Clip the doors onto the plates.
- 9
Handles
Fix the handles (2) with M4 screws through the front from inside. Drill with a template and a scrap board behind the front so the face doesn't chip.
- 10
Adjustment
Adjust the fronts: 3-4 mm gaps, edges in line with the neighbours. A hinge has three screws - side, height and depth.
- 11
Plinth
The plinth clips onto the legs - last, once the whole kitchen is in place and levelled.
The instructions are made by the same program that makes the cutting list - panels carry the same labels (P1, P2…) and the same number of screws and hinges as the hardware list.
Design your kitchen
With an order you get a cutting list with the same labels and a PDF guide for the whole kitchen.
Design your kitchen